Use radio inform IC as to status as it changes.

0

Set brakes and wait for all clear from C.

Locate water source.

Set wheel chocks and tell driver / water engineer(A).

Push in clutch, Put in Neutral, Engage pump. (Pull up red knob in front of seat on floor.)

Take hydrant wrench and 2 ½” Y-splitter to hydrant, optionally a 2 ½” gate valve.

Pull quick connect line and set up to shoot water.

Open tank to pump valve.

Open hydrant side covers, one or two depending on extra gate valve use.

If water is needed, spin up the pump as needed by C, max rpm = 2000.

Flush water till clear.

Pull valve to rear (passenger side) discharge outlet.

Attach splitter and optionally gate valve.

Squirt water. You have at most 300 gallons of water in the tank.

Radio IC , say water being used.

Check with 4201 to see if need a 5” connection or 5” gate valve.

Connect 2 ½” fill hose to truck input connection.

Connect 2 ½” line to hydrant.

Check with water engineer and when ready, Open 2 ½” hydrant valve.

Open fill tank valve.

Close tank to pump valve

Check water level in tank, keep it at ¾ to full level.

Attach 2 1/2” output line.

Pull 2 ½” line to fire scene.

Connect 2 ½” nozzle to line.

GET HELP and tell water engineer (A) ready to go.

Do not try this alone!

Open 2 ½” output valve. (Slowly!)

Squirt water.

All done!

All done!

All done!

Clean up the mess!!!!!!!!!!!!!!!!!!